![]() (25 mm) in thickness are contained in Reference Radiographs E505. Note 2-Reference radiographs applicable to aluminum and magnesium die castings up to 1 in. (216 by 279-mm) cardboard frame and illustrates eight grades of severity for the discontinuity (with the exception of discrete discontinuities, where only one example of each discontinuity is given). Each plate is held in an 8 1/ 2 by 11-in. II: The set of reference radiographs consists of four plates covering discontinuities in magnesium-alloy castings only. The adjunct reference radiographs of any issue remain valid and may be used to this standard. There have been no revisions to the adjunct reference radiographs since original issue. ![]() The reference radiographs are not impacted by this revision. The cardboard frames are contained in a 10 1/ 2 by 11 1/ 2-in. (216 by 279-mm) cardboard frame and each plate illustrates eight grades of severity for the discontinuity in approximately a 2 by 2-in. You may obtain it from The American Society for Testing and Materials, 100 Barr Harbor Drive, West Conshohocken, PA 19428-2959. Each plate is held in an 8 1/ 2 by 11-in. For guidance you may use the following technical reference: ASTM E 119-98, Standard Test Methods for Fire Tests of Building Construction and Materials. Note 1-Vol I: The set of reference radiographs consists of 13 plates covering discontinuities in aluminum-alloy castings and 10 plates covering discontinuities in magnesium-alloy castings. ![]() It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. ![]() The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.ġ.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. Magnesium-alloy digital reference images are not currently available from ASTM International.ġ.3 This document may be used where no other applicable document exists, for other material thicknesses for which it has been found to be applicable and for which agreement has been reached between the purchaser and the manufacturer.ġ.4 The values stated in inch-pound units are to be regarded as the standard. If performing digital radiography of aluminum-alloy castings, refer to Digital Reference Image Standard E2422. The reference radiograph films are an adjunct to this document and must be purchased separately from ASTM International if needed.ġ.2 These film reference radiographs are not intended to illustrate the types and degrees of discontinuities found in aluminum-alloy castings when performing digital radiography. The castings illustrated are in thicknesses of 1/ 4 in. Historical ASTM E155-10 Standard Reference Radiographs for Inspection of Aluminum and Magnesium Castingsġ.1 These reference radiographs illustrate the types and degrees of discontinuities that may be found in aluminum-alloy and magnesium-alloy castings. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |